| Subject | Text |
| Sony SS-CR64 Surround Sound Speaker System | I need the instructions for the Surround Sound and Dolby features on this unit. The center speaker |
| Sony SS-CR64 Surround Sound Speaker System | I need the instructions for the Surround Sound and Dolby features on this unit. The center speaker |
|
|
| Emerson MS9920TT speaker problem | I just recently acquired this three-component stereo system, but it has a speaker issue. Signal is |
| hk amplifier low level speaker output | I have a harman kardon avr 130 amp that has a very distorted and low left surround level speaker out |
| Yamaha RX-V520 Main Speaker not turning on | Hi,
I have a Yamaha RX-V520 A/V receiver which up until recently worked fine. About a month ago o |
| locked out | I talked to a Toshiba repair guy... he said the front panel can be unlocked with the remote... since |
| Sony Amp - The woes continue | Andreas,
Try removing every input and output and see what happens, then add them back one by one |
| str-de945 problem | Is the action (or lack thereof) intermittant? If so, it is likely a bad solder joint. The IR sensors |
| SONY STR KSL5 Protect Fault | I have a SONY STR KSL5 home cinema system which after about 5 mins shuts off with the word "PROTECT" |
| Here's the parts that I used:
[url=R509 100K Ohm 1W resistor[/url] - got an set on Amazon. I prob |
| yeah! tv still working but, always need to push the reset button in front. otherwise no signal with |
| repairing an old sansui amplifier | hello every one ,
new member here and also newby in the electronic repair
i have an old sansui |
| Dead Black Diamond BD28WS | Hello to everyone this is my first post here. I have a BD28WS Black Diamond TV. The fault is when I |
| Looking for Pioneer VSX-D307 Receiver Service Manual | I'm looking for a service manual (or at least a schematic) for my Pioneer VSX-D307 Receiver.
Anyo |
| voltage for relay | hi,i have a problem on my yamaha rx-v392 model...i need to know what is the voltage of the relay in |
| Re: Onkyo TX-SV535 Amp / Remote Speakers NOT Working | [quote:586d3411be="kayecross"]I can not get the remote speaker button to work on my amp. I have inst |
| Hi again,
By bypassing the main speaker relay everything works great. Does anyone know if this mi |
|
|
| avr 130 one of the surround outputs is very very low | got a harman kardon avr 130 one of the surround outputs is very very low
when i connected speaker t |
| Re: Do this test | Forgot to mention: Keep CD player's volume quite low to keep from exceeding input level rating of yo |
| Protect mode occurs when an overcurrent situation is detected by the power supply in the amplifier. |
| Headphone circuit for TV needed. | Hello all. I hope this is the right place for my question. Ok, I have a infrared wireless headphon |
| Toshiba locked out | Thank you Minnie
Is there a way to unlock the front panel???
Heinz |
| Blowing speaker protection fuse suggests failure of the power amplifier output transistors. If a DVM |
| Hi,
Few things u can check:
1. Does the set power up?
2. Speakers - are they connected prop |
| Siemens Gigaset 4010 Comfort problem | Can make call but can't disconnect (end it.) If I call someone and try to end call only sound is tur |
| I agree with Miguel. if your mixer has PAN controls just turn all of them to the same end so your ch |
| AKAI AM-A2 (help) | Hey. I Picked up an ''AKAI AM-A2 model Stereo Integrated Amplifier'' the other day. An electrician s |
| Or check there isn't a speaker/magnet near the T.V.! |
| Upon pressing "Power" you hear a (power) relay "click."
A second or two later |
| .. thats the same problem ive encountered with my sony mhc-vx777. the display reads "protect, push p |